Operating instructions

Cleaning and maintenance G3 Series
Operating resources
7-4
000001,07,12-2008, jmu
7
7.3.2 Cleaning fluids
Attention !
The use of incorrect cleaning fluids not approved by Zünd will damage the machine.
Only use cleaning fluids recommended by Zünd Systemtechnik.
Do not use abrasive cleaning fluids. Caustic substances and scouring agents can
damage surfaces of the cutter (e.g. operating unit).
7.3.3 Lubricants
X/Y axis guide rails, bearings
This machine uses a specially adapted synthetic lubricant which is also used in the
food and pharmaceutical industry. This is characterised by good water resistance
and corrosion protection and can be used at a temperature range from -25 °C to +120
°C.
Gears
To lubricate the gears, a Teflon special grease is used for precision gears in order to
reduce friction.
7.3.4 Adhesives
Conveyor belt
Screw locking
Only use adhesives for screw locking if this is specifically stipulated in the service
manual.
Cleaning fluids Place of use
Plastic cleaning fluid Covers, metal parts
Description Specification
Klüberoil
®
4UH1
Description Specification
Fin Grease MP 2/3 -
Description Specification
Körapur 784/5
Description Specification
Loctite 243