Operating instructions

G3 Series Cleaning and maintenance
Maintenance jobs
7-11
000001,07,12-2008, jmu
7
7.7.2 Maintenance position
Warning !
Danger of injury
The cutter may be put into operation by third parties.
• Always place the cutter in the maintenance position before carrying out mainte-
nance work!
Unless expressly required otherwise, move the machine to the maintenance position
before starting maintenance work.
Fig. 7-3 Secure the machine
– Switch off the machine using the main switch.
– Protect the machine against unauthorised start-up (block the on/off switch with a
lock)
7.7.3 Visually inspect the machine for damage
Attention !
There is a risk of injury if the machine is damaged
Before daily commissioning ensure that there is no damage to the machine.
• Never start up a damaged machine.
• Have damage repaired immediately by authorised service personnel
Daily checks
• Walk around the cutter and check the machine for damage.
• Make sure that all the covers have been fitted. Fit any covers that are missing.