Operating instructions

Cleaning and maintenance G3 Series
Maintenance jobs
7-18
000001,07,12-2008, jmu
7
⇨ Screw the lubrication connection of the lubrication set onto the guide rails behind
the bar (A, B)
⇨ Press the syringe until the feed line is ventilated
⇨ Position the guide bearings above the lubrication connection (C)
⇨ Use the syringe to insert approx. 1 ml of oil into the guide bearing (D)
⇨ Move the bar forwards and backwards 10 times over the length of the guide
carriage via the lubrication connection (E)
⇨ Use the syringe to extract remaining oil. Then move the bar forwards (F)
⇨ Clean the guide rails using a lint-free rag (G)
⇨ Remove the greasing set
⇨ Lubricate the guide bearing on the other side in the same way
⇨ Fit the covers