Operating instructions

G3 Series Product description
Technical description
2-11
000003,04,02-2009, jmu
2
2.7.3 Complete machine
Table/vacuum plate
The work surface is designed as a perforated sheet. Vacuum zones are arranged
under this perforated sheet which are connected to a high-performance vacuum
generator via a distributor.
The vacuum is used for holding down and tightening the material to be processed.
The cutter control permits sequential activation/deactivation of the individual vacuum
zones and therefore reduces energy consumption. The vacuum generator (turbine
vacuum generator, vacuum pump) automatically regulates the vacuum strength (100
mBar).
Electronics unit
The electronics unit is housed in the front right-hand side of the cutter and is only
accessible for service personnel via a removable cover. The cutter control is housed
in the electronics unit.
Power unit
The power unit is housed in the rear right-hand side of the cutter and is only
accessible for service personnel via a removable cover. The power unit contains the
power supply of the complete cutter and is activated/deactivated using an on/off
switch. The connection of the individual consumers takes place using software
control if required.
Pneumatics
Air pressure and air flow are adjusted for the respective consumer via a maintenance
unit. The maintenance unit is accessible via a service door so that settings and
maintenance work can be carried out.