Operating instructions

Product description G3 Series
Technical information
2-20
000003,04,02-2009, jmu
2
2.8.7 Emissions
Noise
Depending on the tool system and materials to be processed:
– if the limit value of 85 dB (A) is exceeded,
– noise protection measures may be necessary
Important !
Protective measures against noise and emissions (dust, solvents, material residues
etc.) for each tool system are specified in chapter 3.
Electromagnetic emissions
The G3 series meets requirements of the following technical standards:
• EN 61000-6-2 EMC, interference resistance in industrial environments
• EN 61000-6-4 EMC, emission standard in industrial environments
Please ask the manufacturer if you wish to refer to the test reports.
2.8.8 FCC approval
NOTE:
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
NOTE:
Changes or modifications made by the user that are not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
Continuous sound pressure level of the cutter < 75 dB (A)