Operating instructions

Controls and operation G3 Series
Operation
4-24
000010,06,02-2009, jmu
4
4.6.3.1 OFFLINE
Attention !
Risk of injury due to automatic starting of the machine
In the OFFLINE operating status, the cutter receives commands from the operating
software. These commands can be used to switch to the operating status ONLINE.
• Activate the operating status STOPPED during breaks.
• Always carry out set-up work in the operating status STOPPED.
When the machine is switched on, the operating status OFFLINE is active.
In this status, commands are received from outside but they are not processed.
Operating software commands can be used to switch to the operating status
ONLINE.
A red flashing LED on the ONLINE key indicates that the operating status
OFFLINE is active.