Operating instructions

G3 Series Controls and operation

Operation

4-35

000010,06,02-2009, jmu

⇨ Move the module to the lower right-hand corner

⇨ Use to switch to the operating status STOPPED

⇨ Insert the selected tool into the module holder. Ensure that the red point on the

module is located above the module lock

Important !

The tool holder and a holding fixture are each marked with a red dot. The tool is in

the correct position when the dots are aligned.

⇨ Lower the shaft of the tool into the module opening until it stops

⇨ Press the module lock and latch the bayonet catch

⇨ Turn the tool in a clockwise direction until the first notch on the positioning

bracket engages with the positioning spindle

⇨ Connect the tool to the connector socket

4.6.7 Connecting driven tools - allocating port

Driven tools (e.g.: EOT, DRT, POT) require an energy supply (electrical, pneumatic).

This energy supply is controlled by the cutter control unit. Electrically driven tools are

inserted into the intended port on the connector control of the laser pointer/ICC

camera. Pneumatically driven tools are already internally connected to the

compressed air supply. A port is allocated to each individual connection which must

be assigned via the cutter control unit before the initial commissioning of the

respective tool. There are 3 electrical connections (ports) available on the distributor

of the laser pointer/ICC camera. Pneumatic tools can be assigned to other ports.

Connection - pneumatic tools

Procedure

⇨ The tool is attached and allocated to the module

⇨ Use

Tool connector

1-1-1-3-1-1 to allocate the tool connection to the

corresponding port

✓ The tool is ready for use

1 Bayonet catch 4 Positioning spindle

2 Module lock 5 Positioning bracket

3 Connector socket

Tool Connection (port)

POT Port 4