Operating instructions

G3 Series Controls and operation
Operation
4-37
000010,06,02-2009, jmu
4
4.6.7.2 Connect pneumatically driven tools
Pneumatically driven tools and modules are connected to the interface unit on the
module carriage. The pressure is set using a maintenance unit. The air supply is
connected to the local installation or supplied via a compressor. The connection data
and connection procedure may be found in the operating instructions for the
appropriate tool/module.
Important !
Always use a stopper to protect connection P4 from dirt in the air supply. If particles
of dirt reach the tool, it will be damaged.
Interface unit - connections
Fig. 4-22 Interface unit - connections
P1 PUM/NOM (Punch/notch module)
P2 Various tools with a working pressure of 0.6 MPa
P4 POT