Installation Manual

5. Record your programming choices in the worksheets in the back of the

manual.

6. To exit press [#].

3.4 Identified Wireless Keys

Reporting by the system of openings/closings by individual wireless keys and

command output [✱][7] activation by wireless key buttons may be supported on

certain control panels. To do this, the system will reserve access codes 17 – 32

for wireless keys 01-16 respectively. You must program one access code for

each wireless key (using [✱][5] access code programming) for this feature to

work correctly.

NOTE: Program these access codes on the system

after

you have connected

the PC5132 to the Keybus (see section 2.4).

Refer to your system Installation Manual for information on access code

programming.

Opening/Closing By Wireless Key Reporting

NOTE: The Identified Wireless Key Closing option is only available with the PC501X,

PC1555, PC580 v2.0 and higher by turning section [015] option 4 off.

To enable the reporting of openings and closings

by identified wireless keys:

• Make sure the control panel is v2.0 or higher

• Program a valid access code for each key

• Program a closing and opening reporting code for each key’s access code

• Turn off the Quick Arm option in section [015] option [4] of the control

panel programming

To ensure that an

unidentified wireless key

cannot disarm the system, turn off

section [017], option [1] (in the control panel programming). This option is

available in control panels with software version 2.1 or higher.

Command Output Activation

NOTE: The Identified Wireless Key Command Output Activation feature is only

available with the PC501X, PC1555 and PC580 v2.0 and higher.

To enable command output activation by wireless keys, ensure that:

• The control panel is v2.0 or higher

• Program a valid access code for each key

• Enable the PGM output attribute Requires Access Code for each PGM

output programmed as [✱][7][1-4] in sections [141] to [154].

Now that you have enrolled all the wireless devices, you will need to program

the system to work properly with the devices. See section 4 for more information.

W I R E L E S S D E V I C E S