Installation Manual

ManualsBrandsDigital Security Controls ManualsElectronicsPC5132A-433 & P5132A-433 Receiver

5.1 Test the Reception of Wireless Devices

It is very important to test the proposed placement of each wireless device before

it is mounted. Following these steps will test the signal strength between the

PC5132 and the wireless devices.

You can test all of the devices together (global placement testing) or test each

device individually. To test all the devices together, see ‘Testing All Wireless

Devices Together’ below. To test wireless devices individually, see ‘Testing

Individual Devices’.

NOTE: After you have enrolled the wireless devices, you must exit and then re-enter

Installer’s Programming at least once before you can perform a placement test.

Testing All Wireless Devices Together:

1. Temporarily put the WLS904-433, WLS906-433 and WLS925-433 devices

in the places you want to mount them.

2. At a system keypad, enter [✱][8][Installer Code].

3. Enable the Global Module Placement test by entering section [804]. Then

enter sub-section [90] and turn on option [8].

4. Press [#] twice.

5. Enter programming section [904], then enter [01].

6. Activate one of the devices being tested until a result is displayed on the

keypad or sounded by the keypad or bell:

WLS904-433:

To perform a Placement Test on the WLS904-433,

remove the detector from the back plate and then replace it. Once the

detector is replaced on the back plate the LED on the detector will flash

rapidly 5 times to indicate that it has sent a transmission. The panel will

show and/or sound the result of the placement test on the keypad. To

perform a 2

and 3

test, repeat this procedure.

Carefully replace theCarefully replace the

Carefully replace the

backplate onto the detector, ensuring that “TOP” is facing upward,backplate onto the detector, ensuring that “TOP” is facing upward,

backplate onto the detector, ensuring that “TOP” is facing upward,

or you may damage the tamper switch.or you may damage the tamper switch.

or you may damage the tamper switch.

NOTE: When you remove the detector from the backplate (tamper the unit),

the detector will also be put into “Detector Walk Test” mode. While in Walk Test

mode the detector will activate the LED when motion is detected. The detector

will also send a signal to the receiver 5 seconds after motion is detected,

indicated by 5 rapid flashes by the LED. The LED will only work in this fashion

for 10 motion detections after a tamper/restore. Note that the panel will ignore

these transmission signals with respect to a placement test. The only way in

which the panel will acknowledge a placement test is if the backplate has,

each time, been removed and restored.

WLS906-433:Remove the detector from its backplate, wait 5 seconds

and re-attach it, or hold a magnet near the raised line on the outer rim,

then remove it.

WLS907-433/WLS925-433: Open the contact by moving the magnet

away from the unit. The keypad will show/sound the test result. After the

first test result has been generated (about 10 seconds) close the contact

to generate another test result. If the unit is attached to a door or a

window, open and close the door or window to activate the device.

S E C T I O N 5

Testing & Mounting