Installation Manual

12
T E S T I N G & M O U N T I N G
WLS909-433: Press any function key at several different locations.
Read the test results at the keypad:
Result LED Keypad LCD Keypad Buzzer/Bell
Good Light 1 On Steady “Good” 1 Beep/Squawk
Bad Light 3 On Steady “Bad” 3 Beeps/Squawks
Activate the device until you get 3 ‘good’ results in a row.
You may mount the WLS devices where results were good.
Devices indicating a bad result must be moved to another location. You
may only have to move the device a few inches to correct a bad result.
NOTE: Do not mount any device where a “bad” test result was indicated.
7. Go to the next device to be tested and activate it until the test result is
displayed/sounded.
NOTE: Wait until the placement test of one device is shown/sounded before
beginning to test the next device.
Continue to test the devices until both the PC5132 and the devices are in
good locations. If several wireless devices produce ‘bad’ test results, you may
need to move the PC5132 to a better location. (See section 2.2 for tips on
finding a location for the PC5132.)
8. To exit the placement test and return to installer programming, press [#] twice.
Testing Individual WLS904-433, WLS906-433, WLS907-433 and
WLS925-433 Devices:
1. Temporarily place the WLS904-433, WLS906-433 or WLS925-433 where
you want to mount it.
2. At a system keypad, enter [✱][8][Installer Code].
3. Enter programming section [904].
4 Enter the 2-digit zone number for the device to be tested.
5. Activate the device being tested until a result is displayed on the keypad
or sounded by the keypad or bell. (Same as step 5 in the Global
Placement Test section, previous page.)
6. To test another device, press [#] once, then repeat steps 4 - 5. Continue
to test the devices until both the PC5132 and the devices are in good
locations.
If several wireless devices produce ‘bad’ test results, you may need to
move the PC5132 to a better location. (See section 2.2 for tips on finding
a location for the PC5132.)
7. To exit the placement test and installer programming, press [#] twice.
Testing Individual Wireless Keys:
You cannot use the individual device test described above to test WLS909-433
wireless keys. To ensure that the PC5132 receiver is receiving transmissions
from these devices, use the function keys on the WLS909-433 at several
different points in the installation.