Installation Manual

S E C T I O N 2

This section describes how to set up and wire the PC5132 module.

2.1 Unpack the PC5132

Check that the following parts are in your PC5132 package:

• PC5132 PCB • Diversity antennae

• PC5132 plastic cabinet • Hardware for mounting the cabinet

2.2 Choose a Mounting Location for the PC5132

NOTE: Mount the PC5132 receiver and wireless devices after you have done

placement tests with the wireless devices (see sections 5.1 and 5.2).

Find a place that is:

• Dry

• Central to the proposed placement of all wireless devices

• As high as possible

• Far from sources of interference, including: electrical noise (computers,

televisions and electric motors in appliances and heating and air

conditioning units); large metal objects like heating ducts and plumbing

which may shield the antenna.

Make sure that electrical wires will not run over the antenna(s) of the module

when it is mounted.

When mounting the PC5132 in a basement, place the module as high and as

close to the underside of the first floor as possible. The range of the module will

be reduced if the unit is mounted below ground level.

2.3 Installing the Antennas

The two antennas must be screwed into the terminals marked ANT1 and ANT2, not

GND1 and GND2. Also they must be installed as indicated in the following two diagrams:

Do not install the antennas as indicated in the following diagrams:

If the antennas are installed incorrectly the PC5132-433 may not

reliably receive signals from the transmitters.

2.4 Connect the PC5132 Receiver

CAUTION: Remove all power from the system while

connecting modules to the Keybus.

Connect the PC5132 to the four-wire Keybus of the

control panel according to the following diagram.

After you have completed the wiring, reconnect the power to the security system.

Now that you have wired the PC5132, you should enroll and program the

wireless devices. See section 3 for instructions.

PC5132 Set up & Wiring