Installation Guide

Section 1.2: Installing The NT9010
9
Keyswitch Zone Wiring
Zones may be programmed to be used as
keyswitch arming zones and must be
wired according to the following diagram:
For a complete description of how key-
switch zones operate, see 2.3.1 Zone
Definitions on page 36.
Connecting the Remote Sounder
You can connect a hardwired remote sounder to the NT9010 system. This sounder
provides an additional station for the NT9010 to sound alarms and system status,
and for central station talk/listen-in sessions.
Connect the remote sounder to the NT9010 con-
trol unit as shown below:
For the sounder to work on the system you must
also turn on the Remote Annunciation option.
When this option is turned on, the remote
sounder will also be supervised.
The Local Annunciation option controls the
sounder in the NT9010 control unit. If you turn
this option off, there will be no alarms or voice
prompts from the NT9010. If both options are on, there will be sound from both
the NT9010 and the Remote Sounder.
If there is a Remote Sounder on the system and it does not report a supervisory sig-
nal within 30 seconds, a “Service Required” trouble will be generated, and a
“Remote Sounder Trouble” event will be logged in the buffer.
See also 2.3.13 Talk/Listen-in Programming on page 49.
Local Annunciation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [017], Option [4]
Remote Annunciation . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [017], Option [5]
Attach NT9010 to Backplate
NOTE:
Before attaching the backplate, be
sure to connect the battery. See 1.2.5 Connecting
the Battery on page 6.
When you have mounted the backplate to the wall,
completed the wiring, and connected the battery, you
can attach the NT9010 unit to the backplate.
1. Push the bottom of the NT9010 onto the back-
plate posts, as shown at right.
2. Snap the top of the NT9010 onto the top of the
backplate, as shown at right.
3. Secure the NT9010 to the backplate by replacing
the plastic screw in the top of the NT9010.
WALL
1. Push bottom
of NT9010 onto
backplate posts
2. Snap top of
NT9010 onto
top of backplate