Installation Guide

Section 1.2: Installing The NT9010

duct a dial tone search before dialing. If necessary, you can enter the following

hexadecimal digits in the telephone number:

• HEX B to dial “✱” (function button B “Away”)

• HEX C to dial “#” (function button C “Chime”)

• HEX D for an additional dial tone search (function button D “Exit”)

• HEX E to insert a 2-second pause (function button E “Status”)

When you have finished entering the telephone number, press [✱]. The system will

recite the number back to you.

Entering the Account Code

The system will send the account code to the central station when communicating

system events (e.g. Low Battery, Test Transmission). Enter a 4-digit code.

Testing the Placement of Wireless Devices

Each wireless detector must pass three consecutive placement tests before it will

work properly on the system. Follow the instructions in Flash Programming to con-

duct the tests. The buzzer will squawk once for “Good” placement and three times

for “Bad” placement.

If you exit the Placement Test section before all the zones have passed the neces-

sary placement tests, a General System Trouble is generated. This trouble can only

be cleared by re-entering the Placement Test and testing all of the devices that have

not yet passed, or by deleting the serial numbers of the devices that did not pass

the test (see 1.2.9 Deleting Wireless Devices on page 13).

NOTE:

Deleting or passing the zone through DLS will not clear this trouble.

1.2.8 Other NT9010

Options

After all zones have passed the Placement Test, Flash Programming will move to the

advanced programming sections. If you do not need to do more programming,

press [#] to exit.

If you need to complete programming not covered by Flash Programming, please

see Chapter 2: Advanced Programming on page 15 . For example, you may

need to change the definitions of one or more zones. This programming is

described in 2.3.1 Zone Definitions on page 36.

1.2.9 Deleting

Wireless

Devices

To remove a wireless device from the system, you will need to use the advanced

programming sections.

1. Press [✱][8], then enter the Installer’s code. The default Installer’s code is [5555].

3. When prompted, press [2] to go to advanced programming.

4. Enter [804], then enter the 2-digit number of the zone you want to delete (01 -

32). The system announces the current serial number for the zone.

5. Program the serial number for the zone as [000000]. The wireless device for the

zone will be removed.

NOTE:

You may need to remove power from the system and then restore

it to clear troubles caused by deleted zones.