User's Guide
Table Of Contents
- Quick Reference Guide
- The following chart lists the basic functions of your system, and the keys to press for each func...
- Turn on system (Away): [access code], leave through entry/exit door 9 OR press Away (if enabled)
- Turn on system (Stay): [access code], do not leave premises 10 OR press Stay (if enabled)
- Turn off system: [access code] 8
- Turn on system (No Entry Time): [access code] 11
- Turn on system (Quick, if enabled): (from Ready state) 10
- Turn on rest of system (if Stay armed): OR press Interior (if enabled) 10
- Exit premises when system on: OR press Exit (if enabled) 12
- Turn off zones (Bypass): [two-digit zone number(s)], to exit 15
- Test system [master code] 17
- Send Fire message: (press & hold for 2 seconds, if enabled) 14
- Send Auxiliary message: (press & hold for 2 seconds, if enabled) 14
- Send Panic message: (press & hold for 2 seconds, if enabled) 14
- Silence fire alarm: [access code] 13
- Silence intrusion alarm: [access code] 14
- Turn door chime on/off: to toggle on or off 20 OR press Chime (if enabled)
- Check alarm memory: 14
- Check troubles 16
- Set time and date: [master code] 20
- Table of Contents
7
Section 3: Turning Your System On
(Arming) and Off (Disarming)
This section describes how to turn your system on and off. Read this section care-
fully.
Tur ning On
Your System
1. Before you turn on your system, make sure that it is Ready. You can tell that the
system is ready when the green (Ready) light is ON.
If the green light is not on,
see the Note below
.
2. Enter your access code on the keypad. If you have entered the wrong code, the
keypad will sound one long beep - try again to enter the correct code.
When you enter a valid access code:
• The keypad sounds fast beeps.
• The red (Armed) light turns ON.
• The keypad starts to beep once every second. This tells you that the system
is turning on (Audible Exit Delay).
3.
If you will be leaving
, go out through the entry/exit door. Doing this tells the sys-
tem that you are away, and the system turns on completely.
If you will be staying
, do not open the entry/exit door. This tells the system that
you are staying, and the system turns on only the perimeter areas.
NOTE: If the green (Ready) light is not on:
• Close all doors and windows
• Stop motion in all areas with motion detectors
If the yellow (Trouble) light is ON, check for possible trouble conditions (see
Checking Trouble Conditions
on page 16), and check that no zones are
turned off unintentionally (see
Turning Off Part of Your System (Bypassing
Zones)
on page 15).