User's Guide
Table Of Contents
- Quick Reference Guide
- The following chart lists the basic functions of your system, and the keys to press for each func...
- Turn on system (Away): [access code], leave through entry/exit door 9 OR press Away (if enabled)
- Turn on system (Stay): [access code], do not leave premises 10 OR press Stay (if enabled)
- Turn off system: [access code] 8
- Turn on system (No Entry Time): [access code] 11
- Turn on system (Quick, if enabled): (from Ready state) 10
- Turn on rest of system (if Stay armed): OR press Interior (if enabled) 10
- Exit premises when system on: OR press Exit (if enabled) 12
- Turn off zones (Bypass): [two-digit zone number(s)], to exit 15
- Test system [master code] 17
- Send Fire message: (press & hold for 2 seconds, if enabled) 14
- Send Auxiliary message: (press & hold for 2 seconds, if enabled) 14
- Send Panic message: (press & hold for 2 seconds, if enabled) 14
- Silence fire alarm: [access code] 13
- Silence intrusion alarm: [access code] 14
- Turn door chime on/off: to toggle on or off 20 OR press Chime (if enabled)
- Check alarm memory: 14
- Check troubles 16
- Set time and date: [master code] 20
- Table of Contents
18
Te s t i n g Yo u r
System
Test your system every week. Report any problems immediately to your installation
company.
NOTE: Perform system tests during off-peak hours, such as early morning
or late evening.
1. If your system has remote monitoring, call the central station to tell them that
you are testing your system.
2. Begin with the system turned off. Press [Master Code] . The system
sounds the siren and turns on all keypad lights for two seconds. When the
sounder and keypad test is complete, press .
3. To test each area of your system, open each door and window in turn, or walk
in motion detector areas.
4. View the display to see all open zones.
5. If the system has any fire zones, activation will cause the alarm to sound in a
pulsed mode. To silence the alarm, press .
CAUTION: Do not use an open flame or burning materials to test a smoke
or heat detector. Contact your installer for information on safe methods of
testing detectors.
6. When you are finished testing the system, inform your central station. If the
system did not work properly, contact your installer.
NOTE: Some features described above will not be functional unless
enabled by your installer. Ask your installer which features are functional
on your system.
Allowing
Computer
Access to Your
System
From time to time, your installer may need to send information to, or retrieve
information from your security system. Your installer will call your system over the
telephone line using a computer. You may need to prepare your system to receive
this “downloading” call. To do this:
1. Press [Master code] . This allows downloading for 1 or 6 hours
depending on your installer’s setup. During this time, the system will answer
incoming downloading calls.
For more information on this feature, ask your installer.
6
*
4
#
#
6
*
5