User's Guide
Table Of Contents
- Quick Reference Guide
- The following chart lists the basic functions of your system, and the keys to press for each func...
- Turn on system (Away): [access code], leave through entry/exit door 9 OR press Away (if enabled)
- Turn on system (Stay): [access code], do not leave premises 10 OR press Stay (if enabled)
- Turn off system: [access code] 8
- Turn on system (No Entry Time): [access code] 11
- Turn on system (Quick, if enabled): (from Ready state) 10
- Turn on rest of system (if Stay armed): OR press Interior (if enabled) 10
- Exit premises when system on: OR press Exit (if enabled) 12
- Turn off zones (Bypass): [two-digit zone number(s)], to exit 15
- Test system [master code] 17
- Send Fire message: (press & hold for 2 seconds, if enabled) 14
- Send Auxiliary message: (press & hold for 2 seconds, if enabled) 14
- Send Panic message: (press & hold for 2 seconds, if enabled) 14
- Silence fire alarm: [access code] 13
- Silence intrusion alarm: [access code] 14
- Turn door chime on/off: to toggle on or off 20 OR press Chime (if enabled)
- Check alarm memory: 14
- Check troubles 16
- Set time and date: [master code] 20
- Table of Contents
20
Erasing a code
1. Press [Master Code]
2. Enter the number of the code you want to erase [01 to 32]. The Master code
cannot be erased.
3. To erase the code, press .
4. To exit access code programming, press .
Setting the
Time and Date
You should make sure that your system has the correct time and date. This is
important for the auto-arm feature to function correctly, and for accurate report-
ing of events.
1. To select time and date, press [Master Code] .
2. Enter the time in hours and minutes using the 24 Hour format (00:00 to 23:59)
then enter the date in months, days and years (MMDDYY) (November 26, 2000
= 112600).
4. To exit programming, press .
Tur ning the
Door Chime
On or Off
If your installer has enabled the door chime feature, your NT9005 will beep when-
ever designated doors or windows are opened or closed. Your installer has pro-
grammed which doors and windows will activate the door chime.
1. Press to turn the door chime feature ON
The keypad will beep 3 times.
2. Press again to turn the door chime feature OFF
The keypad will sound one long beep.
The function button
Chime
can also perform the same function if it is
pressed and held for 2 seconds. When door chime is enabled the keypad will
beep 3 times. When door chime is disabled the keypad will sound one long
beep.
Changing the
Pitch of the
Keypad Tone
There are several different tones that can be programmed for keypresses and
other audible indications.
1. Press and hold . The NT9005 will cycle through the different tones avail-
able. Release the key when the tone of your choice sounds.
*
5
*
#
6
*
1
#
4
*
4
*
*
*