User's Guide
Table Of Contents
- Quick Reference Guide
- The following chart lists the basic functions of your system, and the keys to press for each func...
- Turn on system (Away): [access code], leave through entry/exit door 9 OR press Away (if enabled)
- Turn on system (Stay): [access code], do not leave premises 10 OR press Stay (if enabled)
- Turn off system: [access code] 8
- Turn on system (No Entry Time): [access code] 11
- Turn on system (Quick, if enabled): (from Ready state) 10
- Turn on rest of system (if Stay armed): OR press Interior (if enabled) 10
- Exit premises when system on: OR press Exit (if enabled) 12
- Turn off zones (Bypass): [two-digit zone number(s)], to exit 15
- Test system [master code] 17
- Send Fire message: (press & hold for 2 seconds, if enabled) 14
- Send Auxiliary message: (press & hold for 2 seconds, if enabled) 14
- Send Panic message: (press & hold for 2 seconds, if enabled) 14
- Silence fire alarm: [access code] 13
- Silence intrusion alarm: [access code] 14
- Turn door chime on/off: to toggle on or off 20 OR press Chime (if enabled)
- Check alarm memory: 14
- Check troubles 16
- Set time and date: [master code] 20
- Table of Contents
Replacing Batteries
25
Door/Window
Contacts
WLS907T-433
Insert a small screwdriver into the slot on the side of the sensor. Push the screwdriver in and
lift off the cover. Remove the old batteries and install three fresh Eveready Alkaline Ener-
gizer AAA batteries. Insert the batteries, ensuring that the correct polarity is observed. Care-
fully replace the cover.
WLS925L-433
To remove the cover of the universal transmitter,
insert a small flat blade screw driver into the
notches and gently pry open the cover. Pull to
release the cover.Use care when installing the
battery and observe the correct polarity (see dia-
gram). Use only an Eveready Lithium Energizer
No. EL123AP battery.
Caution: Do NOT touch the coiled antenna on the unit.
This can result in improper operation.
Motion
Detectors
WLS904P-433
Remove the motion detector from its mounting plate by hold-
ing the detector by its sides and pushing up. Remove the old
batteries and install four fresh Eveready Alkaline Energizer AAA
batteries. Be sure to observe correct polarity when inserting the
batteries. Replace the detector on its mounting plate, making
sure it snaps into place.
WLS904PL-433
Remove the motion detector from its mounting plate by hold-
ing the detector by its sides and pushing up. Remove the old
batteries and install two fresh Eveready Lithium Energizer
EL123AP batteries. Observe correct polarity when inserting the
batteries. Replace the detector on mounting plate, making sure
it snaps into place.
WLS914-433
Remove the motion detector from its mounting plate by holding the sensor
by its sides and pushing up. Install four fresh Eveready Alkaline Energizer AA
batteries. Be sure to insert the batteries in the proper orientation. Replace
the sensor on its mounting plate, making sure it snaps into place. After the
batteries are installed, the detector will take 60 seconds to warm up. During
this time the LED will flash.