User's Guide
Table Of Contents
- Quick Reference Guide
- The following chart lists the basic functions of your system, and the keys to press for each func...
- Turn on system (Away): [access code], leave through entry/exit door 9 OR press Away (if enabled)
- Turn on system (Stay): [access code], do not leave premises 10 OR press Stay (if enabled)
- Turn off system: [access code] 8
- Turn on system (No Entry Time): [access code] 11
- Turn on system (Quick, if enabled): (from Ready state) 10
- Turn on rest of system (if Stay armed): OR press Interior (if enabled) 10
- Exit premises when system on: OR press Exit (if enabled) 12
- Turn off zones (Bypass): [two-digit zone number(s)], to exit 15
- Test system [master code] 17
- Send Fire message: (press & hold for 2 seconds, if enabled) 14
- Send Auxiliary message: (press & hold for 2 seconds, if enabled) 14
- Send Panic message: (press & hold for 2 seconds, if enabled) 14
- Silence fire alarm: [access code] 13
- Silence intrusion alarm: [access code] 14
- Turn door chime on/off: to toggle on or off 20 OR press Chime (if enabled)
- Check alarm memory: 14
- Check troubles 16
- Set time and date: [master code] 20
- Table of Contents
26
Glassbreak
Detectors
WLS912-433
Remove the detector from its mounting plate by pushing the detector in the direction indi-
cated. Install the three Energizer AA batteries, observing the correct polarity, as shown
below.
WLS912L-433
Remove the detector from its mounting plate by pushing the detector in the direction indi-
cated. Install the two Lithium batteries, observing the correct polarity, as shown below.
Smoke
Detectors
WLS906-433
The WLS906-433 requires six Eveready Energizer AA batter-
ies. To replace the batteries, remove the detector from the
mounting plate by pushing the locking tab and turning the
detector counter-clockwise.
Hold the unit with the battery compartment facing you, and
the imprinted wording right-side up. Install the first two bat-
teries in the row nearest to you, with the + terminals facing
left. Next, install the middle two batteries with the + termi-
nals facing to the right. Place your thumb over the centre of
these four batteries to keep them in place. Install the last two
batteries, with their + terminals facing to the left, by snap-
ping them past the nylon retainer.
Wireless Keys
WLS909-433
The WLS909 requires three Energizer LR44 batteries. To replace the
batteries, remove the screw on the back of the key and carefully sep-
arate the two sides of the key’s plastic casing. Remove the old batter-
ies from the two metal clips. Insert the new batteries according to the
diagram at right and reattach the two sides of the key’s plastic casing.
Battery polarity must be observed
WLS919-433
The WLS919 wireless key requires two lithium CR2032 batteries. To
replace the batteries, open the key’s plastic housing by inserting a flat-
head screwdriver along the side of the unit and carefully twist the
screwdriver to separate the top and bottom plastic. Once separated
the batteries will be visible, remove the old batteries and insert the
new ones.