User's Manual

Read the test results at the keypad.

Result LED Keypad LCD Keypad Buzzer/Bell

Good Light 1 On Steady “Good” 1 Beep/Squawk

Bad Light 3 On Steady “Bad” 3 Beeps/Squawks

Activate the device until you get 3 good results in a row. You may mount the WLS devices

where results were good. Devices indicating a bad result must be moved to another

location. You may only have to move the device a few inches to correct a bad result.

NOTE: Do not mount any device where a “bad” test result was indicated.

7. Go to the next device to be tested and activate it until the test result is displayed/

sounded.

NOTE: Wait until the placement test of one device is shown/sounded before beginning to

test the next device.

Continue to test the devices until both the RF5108-433 and the devices are in good

locations. If several wireless devices produce BAD test results, you may need to move the

RF5108-433 to a better location (see section 2.2 for more information).

8. To exit the placement test and return to installer programming, press [#] twice.

Testing Individual Wireless Devices:

1. Temporarily place the wireless device in the place you want to mount it.

2. At a system keypad, enter [✱][8][Installer’s Code].

3. Enable Individual Module Placement test by entering section [804]. Then enter sub-

section [90] and turn off option [8].

4. Press [#] twice.

Testing Individual Wireless Keys:

You cannot use the individual device test described above to test WLS909-433/WLS919-

433 wireless keys. To ensure that the RF5108-433 receiver is receiving transmissions from

the devices, use the function keys on the Wireless Keys at several different points in the

installation. If the wireless key does operate from all intended points of operation, you will

need to move the RF5108-433 receiver. Moving the RF5108-433 higher will usually

improve the reception. If you move the RF5108-433, you will need to repeat the tests

described in Section 5.1 on all the wireless devices.

5.2 Mount the RF5108-433 and Wireless Devices

When you have tested reception of the RF5108-433 with all the wireless devices (see

section 5.1) and you have a good mounting location, mount the RF5108-433:

1. Pull the Keybus wires through the hole at the bottom of the cabinet.

2. Mount the cabinet securely to the wall.

Mount the Devices

If you have conducted the placement test described in section 5.1 and got three “Good”

results in a row for each device, you can mount the wireless devices. See the

Installation

Sheet

for each device for mounting instructions.

Now that your RF5108-433 and wireless devices are mounted and working properly, read

section 6 for information on potential wireless trouble conditions, RF jamming signals, and

battery replacement.

T E S T I N G & M O U N T I N G