Owner`s manual

10
BVE02 Interface
The control information from the Edit Controller’s ‘Serial (Audio) Mixer’ connector should be
fed into the ‘Editor’ connector of the interface. A second cable should be connected from the
mixer ‘To Host’ connector to the ‘Mixer’ connector of the interface. A composite video
reference should be connected to the internally terminated ‘Sync’ input (this enables accurate
fade timing).
Within the interface there is an eight section setup switch. This is set with Switch 8 ON, all
other switches OFF.
The interface should be powered from the external 12v 1A DC power supply provided.
BVE02-PV
When the PV variant of the BVE02 is installed, the mixer should be configured as described
above. If the optional JLCooper ES4/100-RS422 fader panel is also installed, it should be
connected to Port 2.