Owner`s manual

12
Sony BVE2000
The setup for the audio mixer control is described in the BVE2000 manual section “5-1-6
Setting the Audio Mixer Operating Conditions” As a simple guide the recommended setup is:-
Use page 4 “MIXER CONFIGURATION” of the SYSTEM SETUP MENU.
Change the settings shown on this screen to the following :-
1 MON MODE = BOTH (MIX)
2 PVW MODE = MON
3 MIXER TYPE = SERIAL
4 INIT PANEL REG# = 01
5 CH MODE = 4 CH
6 SAVE IP REG# ONLY = OFF
Use the ENTER key to store these new settings. Use RET key to exit setup mode.
The device assignment page on the BVE2000 should be used to set the audio mixer Machine
number for each VTR. This number will specify the group of mixer input channels that carry
the audio signals from the VTR. The Machine number for the various input group
combinations available is listed in the ‘Machine Assignments’ section of this manual. The
BVE2000 has separate device assignment entries for the MIXER XPT and MON-A audio
Machine numbers of each VTR. Both entries should be set to the same number.
SONY BVE910
Set-up notes for this editor have not been prepared.
System Configuration Security
Once the setup of the edit controller is complete and the correct operation is tested and
confirmed, save the mixer and edit controller or Vision Switcher setup in a user memory that
is then write-protected. Use these as templates for all other setups that include the control of
the audio mixer and as a reference setup if problems occur in the future.
Make a written record of the settings that are required for correct connection and operation
of the audio mixer.
If operator user memories already exist, ensure all these are updated with the settings for
controlling the audio mixer.
If the system is used by freelance operators, ensure they are made aware of the updated
settings and that all their user memories – especially if they keep them on external USB Flash
memory.