User Manual

6
VOYAGER User Manual
Interface
Front button: Power button
Charging/Data port
Side button: Program button
Interface
* All units are delivered in shelf mode to extend
battery life. If you plan to store your units for
longer periods of time, or to prepare them for air
travel, hold down both buttons for +- 10 seconds.
This is also the factory reset procedure. The unit
must be connected to its adapter to be powered
back on.
To power the unit ON/OFF, hold the power
button for 3 seconds.
When turning Voyager ON the Power Sta-
tus LED (1st led) turns from RED to GREEN
and the shader given to Voyager prior shut-
down will be displayed.
When booting unit ON for the
first time after unboxing, the
unit must be connected to
the power adapter*.
If the shader happened to be an anima-
tion or a video than a freeze frame will be
displayed until Voyagers animation engine
boots up.
It will take about 40 seconds until Voya-
ger is booted and ready for use.
Holding the Power Button for less than
2 seconds will indicate the unit’s Charge,
Power and Wifi status:*
The overall amount of LEDs coming on will
indicate the remaining battery life.