Specifications

Net-2000™ VCU Users Manual
Version 4.0, December, 2013
Net-2
000™-VCU Installation
2.2.3.4 Connecting to RS-232
The RS-232 serial port located on the back of the Net-2000™-VCU unit provides low level set-up functions. The
interface itself consists of a simple command/response ASCII text protocol. You can use a terminal or terminal
emulator on a personal computer to type commands at a keyboard as your user interface.
To connect the serial interface, to a Terminal or PC plug a straight-through modem cable (see pin outs in Table 55
Serial P
ort Pin Outs) into the serial port DE-9s connector and plug the other end into your terminal (or one of the
ser
ial ports on your PC if you are using an emulator). Set the terminal as shown in Table 2 Serial Port Terminal Set-
up.
2.3 Rack Mount Installation
When a rack mount kit is purchased with the Net-2000™-VCU the assembly is installed at the factory prior to
shipping. If the rack mount, needs to be removed there are three flat head Philips screws on each side that secures
the rack mount plate to the Net-2000™-VCU chassis as shown below. To avoid scratching the sides of the Net-
2000™-VCU when removing the rack plate push down on the front of the plate so that it slips out from underneath
the unit. When re-installing the rack mount slip it up from underneath and push it back to be flush with front face.
Use the same six screws to secure the rack mount back on the chassis.
Figure 4 Rack Mount Installation
2.4 VCU Front Panel
Net - 2000
Net - 2000
V CU oice odec nit
Digital Voice Systems, Inc.
Figure 5 Net-2000™-VCU Front Panel
(Subject to Change) Page 6
DVSI CONFIDENTIAL PROPRIETARY