Quick Start Guide

Quick Start Guide
Rev: 12/20
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
Safety Warning
• When the lamp is running, it is hot to touch. Before touching
switch o the illuminator and allow to cool for a minimum of
10 minutes.
• The illuminator should be positioned so that prolonged
starring into the illuminator at a distance closed than 1m is
not expected.
• The light source of this illuminator is not replaceable, when
the light source reaches its end of life the whole illuminator
should be replaced.
• If the flexible power cord of the illuminator is damaged it
should be exclusively replaced by an authorized service
agent.
• This equipment is not suitable for us in locations where
children are likely to be present.
NOTE: When using the device for the first time, or if a
factory reset has been made, the following
settings are used.
Default IP address: 192.168.1.10
STEP 3 – WEB INTERFACE
Login
1. Open a web browser.
2. In the address field, type in the selected unit IP address
(see following).
3. The user interface login page is shown.
4. Create your username and password. When connecting to
the for the first time, a password must be set.
STEP 4 – RESETTING THE ILLUMINATOR
Follow the diagram below to locate the reset button on the
side of the illuminator. Unscrew and open the cap and press
the reset button according to the following options:
• 1-2 seconds press: power cycle. The LED will flash once the
button is released.
• 3 seconds press: reset the network and user credential.
The LED will flash 3 times after 3 seconds.
• 10 seconds press: reset to factory setting (erase all). The
LED will flash 3 times after 3 seconds, then will turn on
again when the button is released after 10 seconds.
mount
Reset
Shows LED
Pressure
relief valve
Ethernet cable with
cable cover
RISK
GROUP 2
CAUTION
IR emitted
from this
product
* Options may vary based on the model.