User Manual

ALARM SETTINGS
EVENT - EXAMPLE 1 – INPUT FROM DETECTOR
If an external detector is connected to the telemetry input of the illuminator, users can set
up an event to be triggered from that input signal. Users must add an event in the ‘Event
settings’ tab.
The example below shows an event configuration for an event input from a motion detector,
the input signal is defined as a ‘digital input’. The condition is ‘closed circuit’, which means
when the telemetry pins are closed together, the event will be triggered. The delay is set
to 0 seconds and the time out is 15 seconds. This means the illuminator will be turned on
immediately when the digital input signal is received and will remain on for 15 seconds.
Once the event is saved, it will appear as shown below:
18