User Manual

INSTALLATION

Note:

• Only to be installed beyond arm’s reach.

• Installation should be done by skilled personnel or under the supervision of such

personnel.

• The illuminator is PoE+.

• Only to be installed in restricted access areas.

• Terminal block not included. Installation may require advice from a qualiﬁed person.

Optimum results are achieved by setting it up at night and viewing the results on a monitor.

1. Attach the illuminator mount to wall or camera housing using appropriate hardware.

2. Select a diuser with an appropriate angle based on your installation needs. To position

the required diuser sheet, using the supplied pry tool, insert it into the slot located on the

bottom of the lens. Gently lift the cover upwards slowly. Repeat at the opposite end and

carefully remove the cover. Remove the backing sheet from the two adhesive discs and

secure the required diuser in position. Finally, ﬁrmly clip the lens cover back into place.

3. Adjust the angle of the illuminator to match the camera’s ﬁeld of view.

4. Adjust the vertical alignment by loosening the side bolts (one on each side of the main

body) to maximize the results.

5. Tilt the lamp downwards until the desired ﬁeld of view is illuminated.

6. SLOWLY and GRADUALLY tilt the lamp upwards until the part of the required ﬁeld of view

is illuminated correctly on the monitor.