User guide

63
7K, 9K series
7.2.2 ATTACHING THE RS-422 ADAPTER
Locate the PTZ adapter.
For DW-Pro 7000 (shown) connect the two wires of
the PTZ adapter to the PTZ camera. The red wire
on the adapter should connect to the TX+ on the
PTZ and the brown wire should connect to the TX-.
For DW-Pro 9000 connect the two wires of the PTZ
adapter to the PTZ camera. The red wire on the
adapter should connect to the TX+ on the PTZ and
the white wire should connect to the TX-.
Connect the other end of the adapter to the DVR
unit as shown. Both 7000 & 9000 have similar
connections except the 9000 has only two wires.
Assign the PTZ camera an ID number that
coincides with the number assigned to it by the
DVR unit.
Example: If the camera is plugged into input
number 5, set the PTZ unit to ID number 5.
Inside the DVR PTZ setup, select the PTZ camera
using the Camera Channel drop down menu:
1 Enable the PTZ functions of the camera by placing a check in the Pan/Tilt Connection checkbox.
2 Select the appropriate Protocol and set the PTZ Driver Address and Serial Port Settings (See Advanced
PTZ Setup in the chapter).
NOTE: Protocols are a set of instructions written by the manufacture of the PTZ cameras that allow
software programs such as this DVR to control their functions. The majority of the major PTZ manufacture
protocols are included in this software
3 Click Apply and exit Setup.
4 From the Main Display Screen select the PTZ button (See the chapter on DVR BASICS) The PTZ Control
options will open.
5 Select the PTZ camera to control by clicking on its video on the main display screen. The camera number
will appear inside the PTZ controls.
6 Using the PTZ controls, you should now be able to move the PTZ around.