User manual

2.6 NETWORK

Network Setup allows the user to adjust settings such as ports and transport rate, setup PPP information for use with the Emergency Agent

software, and enable remote access.

1. Disable Remote Controls

Enable/Disable remote access and control of the NVR.

2. View IP Address

View IP address, Subnet Mask, Default Gateway and DNS server address information of the NVR.

3. Network Setup

View and modify all information necessary for setting remote access to the NVR:

a) Time-Out Value

When attempting to connect to the NVR, the connection will be

terminated if the connection does not succeed during the TimeOut

Value (seconds).

b) Emergency Port

Used to connect to the Alarm Monitor software.

c) Center Port

Used to connect to the Digital Watchdog Remote Software. This port

must be specified in the Remote Software to connect to the NVR.

Note: Center Port 1025 is not available for remote connections. It is

used by the ATI VGA Management Suite.

d) Image Port

Used to transfer video(s) to the Digital Watchdog Remote Software.

e) Search Port

Used to transfer search information to the Digital Watchdog Remote

Software. Note: If connecting to the NVR through a firewall, the

above ports must be open to incoming and outgoing traffic.

4. PPPoE Setup

Recommended for Emergency Agent Setup.

5. Transport Rate

This is essentially a bandwidth throttle. The option is based on percentages of images sent or free

network. These settings affect the quality and speed of the video that is sent to the remote clients.