User Manual

DW Spectrum 3.0
Rev. 072017 Page | 105
1. Click on Select at least one camera in the desired row on the Alarm/Event Rules form (see "Configuring Events
and Actions (Admin Only)"). The following form will appear:
2. Check the cameras to display, then click OK (Cancel will discard changes).
To select all Cameras on a specific Server, check the corresponding box. To filter search, use the Filter box. Filter
criteria is the same as search (see "Search"). It is possible to Drag'n'Drop the selected Cameras from Resource Tree
onto the Action's advanced settings form.
Advanced Parameters
Also show on source camera – available only if Event is bound to Cameras. If checked, when Event occurs text will be
displayed on the source Camera too. For instance, if Rule is set up to show Cameras 2 and 3 and motion occurs on
Camera 1, Alarm Layout will contain Cameras 1, 2 and 3. If unchecked, it will contain only Cameras 2 and 3.
Display text for ... Seconds – If checked, the text will be visible for the specified amount of time. Can be unchecked for
the following continuous events: Motion on Camera, Input Signal on Device, Generic Event. If unchecked, text will be
displayed until the event stops. For instance, text will be displayed while the motion is going on on a specific Camera.
Use custom text – if not specified, the event description will be used as a text.