User Manual

DW Spectrum 3.0
Rev. 072017 Page | 134
If all components are installed on one computer, choose Full installation.
Configuring Video Walls
Initial Video Wall configuration is performed in several steps:
 Configuring Video Wall
 Configuring Layout of Video Wall Displays
 Configuring Video Wall on Several Computers
 Switching to Video Wall Mode
 Deleting Video Wall and its Elements.
Since a single computer has a limited number of available video outputs, it can handle limited number of displays. To
extend Video Wall it is necessary to add additional computers and combine them to Video Wall Cluster. See
"Configuring Video Wall on Several Computers".
To change configuration refer to the following sections.
Creating new Video Wall
To enable Video Wall feature it is necessary to obtain and activate Video Wall Licenses (see "Obtaining and Activating
DW Spectrum Licenses"). Each one allows controlling video wall from a single computer (one session) or extend Video
Wall on 2 displays. For instance 4 Licenses allow user to display Video Wall on 8 monitors and control it from 4 Clients
concurrently.
To create Video Wall:
1. Open Main Menu and choose New –> Video Wall.
2. Enter the name of Video Wall and click OK or press Enter.
Configuring Layout of Video Wall Displays
DW Spectrum can display video on unlimited number of displays. To make a computer displays part of Video Wall
(Video Wall Processor) it is necessary to perform the following settings on that computer:
1. Right Click on Video Wall in Resource Tree and choose Attach to Video Wall.
2. Configure Video Wall Screens. DW Spectrum automatiacally detects the number of displays connected to the
computer.
 To add screen click on "+" in the dialog: