User Manual

DW Spectrum 3.0
Rev. 072017 Page | 138
To simplify the calibration process it is possible to display identification information on a particular physical
Display. To do so right click on the desired Virtual Display and select Identify (it is necessary to attach to video wall
first - see above). This initiates displaying identification information on the corresponding physical Display.
5. Fill up Screens. It is possible to place a single Item or whole Layout on each virtual Screen:
To remove Layout from Screen locate it in Resource Tree, or on VIdeo Wall Layout, Right-click and choose Detach
Layout.
6. To save changes right click on Video Wall in Resource Tree and choose Save Current Matrix... and enter the desired
name.
To restore Video Wall View expand Video Wall in Resource Tree right click on saved Matrix and choose Load Matrix...
The configuration is almost done. To finalize it is necessary to Switch Video Wall Processor to Video Wall Mode. After
Video Wall has been started on Video Wall Processor, the current configuration can be changed on Video Wall
Controller.
To open Video Wall on Video Wall Controller do one of the following:
 Drag Video Wall on Scene
 Right Click on desired Video Wall in Resource Tree and choose Open Video Wall(s).
Video Wall Layout will be opened.
Switching to and Exiting from Video Wall Mode
To be able to control Video Wall it is necessary to switch Video Wall Processor to Video Wall Mode. This should be
done on Video Wall Processor.
Usually Video Walls are controlled from Video Wall Controllers and the computers the displays are connected to are
one easily accessible. So it is recommended to set up automatic switching to Video Wall Mode. To do so: