User Manual

DW Spectrum 3.0
Rev. 072017 Page | 48
The following actions can be performed:
 Record Audio from I/O Module (if a microphone is connected). See Setting up Recording Schedule for details.
 Playback Audio Archive Recorded from I/O Module (if a microphone is connected). This is similar to viewing
archive from Cameras (see "Navigating through Archive and Live")
 View Inputs State. When the circuit is grounded, the appropriate sensor turns green
 Trigger Output. For this purpose click the corresponding button (B1-B4 on the picture above). The output signal is
being sent for the amount of time specified in Pulse Time setting.
 Create Rules (see "Configuring Events and Actions (Admin Only)") using the device's Input/Output ports:
 Input Signal on Device
 Trigger Output on Device.
Renaming Devices (Admin Only)
If a device is discovered automatically (see "Automatic Device Discovery"), it is displayed in Resource Tree as a
predefined sequence ("model"or "manufacturer + model"). For instance, 10005 for Arecont Vision cameras or
DWC-MD421D for Digital Watchdog.
Note: It is possible to configure Devices for Administrators and Viewers with an appropriate permission level.
It is recommended to rename same device models for easier identification. Devices can be renamed directly from
Resource Tree using Context Menu (or F2), or in device settings (General -> Name).
IP-addresses are added to a device name automatically and are non-editable. It is possible to deactivate displaying IP
addresses in Resource Tree.
Obtaining Device’s IP, MAC, Firmware and Model
To obtain Device's IP and MAC, open Camera settings and go to General. They will be displayed and are non-editable.