User Manual

DW Spectrum 3.0
Rev. 072017 Page | 60
1. Select the desired Camera(s) in Resource Tree (use SHIFT or CTRL to select several) or on Scene, open Camera
Settings and go to Recording:
IMPORTANT. If Server and Client are in different time zones the schedule displays Server Time.
2. Click
to enable.
( : enabled) .
Check the number of licenses used. If the number is insufficient, click Get More Licenses and proceed with
activation.
Click on Display FPS on Grid and Display Quality on Grid to show/or hide FPS and quality in grid cells.Select
Recording Mode:
 Record Always
 Motion Only – recording will start if motion occurs. To specify a range for motion recording, use Record before
motion and Record after motion selectors. Motion detection must be supported by the camera (Software or
Hardware) and requires secondary(sub) stream.
 Motion + Low Quality Always – low quality stream is recorded always and is switched to high quality streaming
once in case of any motion. To use this recording setting, make sure the camera supports dual-streaming.
If not, the following will be displayed:
Dual-Streaming and Motion Detection is not available for this camera.
 Do not Record
3. Select Recording Quality
4. Select FPS
IMPORTANT. If making any changes to image parameters for Camera is prohibited for DW Spectrum, then FPS
and Recording Quality changes will not take effect. See "Preventing DW Spectrum from Changing Camera Streaming
Settings (Admin Only)" for details.
6. As soon as all the parameters are selected, click on Schedule Grid:
 Click and Drag to select multiple cells
 Click on hour to select an entire column
 Click on weekday to select an entire row
 Click Schedule Grid's top left corner to select all cells
Note: to select same values, hold Alt and click on the cell to choose a recording mode, FPS and values.
7. Repeat to set another recording for different cells