User Manual

DW Spectrum 3.0
Rev. 072017 Page | 61
8. If Motion Recording is set, it is possible to adjust Pre-recording and Post-Recording intervals (the time range
between the start and end of motion recording).
9. Click Apply or OK when finished. To discard changes, click Cancel.
In case of insufficient licenses, the following warning will appear:
License limit exceeded (X of Y used). Your schedule will be saved, but will not take efect
Enable Recording flag will be disabled; however, all schedule settings will be saved.
Example:
 Workdays 8AM-8PM – Record Always, 24 FPS, High
 Workdays 8PM-8AM – Motion + Low Quality Always, 24 FPS, Medium
 Weekends – record motion only, 10 fps, Low
IMPORTANT. Make sure to apply all recording selections to the schedule once selected (recording type, FPS and
quality).
Copying Recording Schedule between Cameras
If Recording Schedule is already set up on Camera it may be needed to copy the settings to a different one. For
instance, if a new camera is plugged in it is much more convenient than set up a schedule separately.
To copy Recording Schedule:
1. Open Camera the schedule should be copied from, go to Camera Settings -> Recording:
2. Click on the Copy Schedule button. The following form will be opened: