User Manual

DW Spectrum 3.0
Rev. 072017 Page | 64
The above picture illustrates the following:
 the area marked in grey will not capture motion (Motion Mask)
 the green area will capture motion with very low sensitivity
 top right and bottom left corners will capture motion with standard sensitivity
 for other regions, the sensitivity will be high.
6. Click Apply or OK when finished. To discard any changes, click Cancel.
It is possible to set up motion directly from camera’s web page. For this purpose, use Camera Web Page link on the
Motion tab.
Configuring Proprietary Device Parameters
DW Spectrum allows configuring basic image settings inside the software. These settings are available for
Onvif-compliant devices only.
Additionally, DW Spectrum allows displaying native device web page inside the software (approved models only).
Note: It is possible to configure Devices for Administrators and for Viewers that have the appropriate permissions.
To go to proprietary device settings:
1. Open Device settings and select Advanced.
2. Configure desired Device Parameters: