User Manual
DW Spectrum 3.0
Rev. 072017 Page | 66
Note: If the list is empty, Device does not support configuring (not Onvif-Compliant).
Other proprietary device parameters such as Authorization, Network Settings etc. can be configured directly from
device’s web page.
1. Open Camera settings and select General tab.
2. Enter Authentication Parameters if the device requires authentication (Admin only).
3. Click on Web Page. The browser will open device’s web page.
Web page may be inaccessible because it can be located on a different network. To check device accessibility, press
the Ping button prior to opening the web page.
Additionally, the following can also be performed:
Resetting Camera
Upgrading Camera's Firmware.
Resetting Camera
DW Spectrum allows for cameras to be reset to factory defaults. These settings are available for Onvif-compliant
cameras only.
Note: It is possible to configure Cameras for Administrators and Viewers with an appropriate permission level.
To go to proprietary camera settings:
1. Open Camera settings and select Advanced.
2. Go to Maintenance.
Note: If the list is empty, Camera does not support configuring (not Onvif-Compliant).
3. Choose one of the following:
System Reboot – reboot Camera and save settings
Soft System Factory Default – reboot Camera and restore all settings related to the image
Hard System Factory Default – reboot Camera and restore all settings (Network, Authorization, etc).
The reboot is performed instantly once selected.
It is also possible to reboot Camera from its Web Page. See "Configuring Proprietary Device Parameters".
Upgrading Camera's Firmware
DW Spectrum allows for Cameras Firmware upgrade from within the application. These settings are available for
supported Digital Watchdog cameras only.
Note: It is possible to configure Cameras for Administrators and Viewers with an appropriate permission level.
IMPORTANT. To enable this feature, Camera must have Internet Access.
To go to proprietary camera settings:
1. Open Camera settings and select Advanced