User Manual

DW Spectrum 3.0
Rev. 072017 Page | 73
2. To add a new Rule, click Add. To delete an existing-one, click Delete.
3. Once added, Rule should be configured.
 Select Event on the left-hand side that needs to be monitored. See "Tracked Events" for more information
 Select Action on the right-hand side that needs to be performed once Event occurs. Refer to "Actions" for
details
 Specify basic parameters for Event and Action. Click on Source or Target column in the Rule row and choose the
desired value.
IMPORTANT. If some fields are missing or incorrect, Rule is considered invalid. In this case, it will turn red:
 Set Aggregation period. Once set, all Actions will be executed once per the specified period. If not, Actions will
be executed every time Events occur. Applies to Notifications, Mail Notifications, Play Sound, Speak.
 If any additional configuration is needed, click Advanced... The advanced settings will be displayed on the
bottom. Those settings differ from each other depending on Events/Actions that are being configured. See this
chapter for more information on a specific Event/Action.
 Add Comments for Rule if needed.
4. Set or clear the flag (on the left-hand side of each Rule) to enable or disable it.
5. As soon as all configurations are done, click Apply to accept changes or Cancel to discard. Click OK to apply changes
and close the form.
IMPORTANT. If any Rule is considered invalid, the warning displayed below will appear. If apply the changes,
incorrect Rules will be disabled.