User Manual

DW Spectrum 3.0
Rev. 072017 Page | 76
1. Click on Any Camera at the desired row on the Alarm/Event Rules form (see "Configuring Events and Actions
(Admin Only)"). The following form will appear:
2. Check the cameras to detect motion, then click OK (Cancel will discard changes).
To select all Cameras on a specific Server, set the flag on it. To filter search, use the Filter box. Filter criterias are
the same as search (see "Search"). It is possible to Drag'n'Drop the selected Cameras from Resource Tree onto the
Event's advanced settings form.
IMPORTANT. To detect motion, recording must be enabled on Camera. Refer to "Modifying Recording
Schedule" for information on how to enable recording. If the selected Camera is not being recorded, then the
corresponding message will be displayed (see above).
If cameras are not specified, motion will be detected on all the cameras that support it.
Advanced Parameters
Schedule (see "Setting up Schedule for Tracking Events").
Starts/Stops. Available only for instant actions (Send Mail, Show Notification, Camera Output). If no motion occurs for
3 seconds, the current motion Event is considered stopped. When motion occurs again, a new motion Event is
generated.
May result in
Camera Recording.
Panic Recording.
These actions are performed while motion is taking place on at least one camera out of the selected.