User Manual

DW Spectrum 3.0
Rev. 072017 Page | 81
To select all Devices on a specific Server, click on the check box. To filter search, use the Filter box. Filter criteria are
the same as search (see "Search"). It is possible to Drag'n'Drop the selected Devices from Resource Tree onto the
Event's advanced settings form.
IMPORTANT. To detect input signals, input must be supported on Device. If the selected Device does not
support input, then the corresponding message will be displayed (see above).
If the particular Devices are not specified, then input signal will be detected on all the Devices that support input.
Advanced Parameters
Schedule (see "Setting up Schedule for Tracking Events").
Starts/Stops. Available only for instant actions (Send Mail, Show Notification, Device Output etc).
Input ID – I/O Module port to take signal from (see Setting Up I/O Moduless).
May result in
Camera Recording.
Panic Recording.
These actions will be performed while input signal is taking place on at least one Device out of the selected.
Send Mail.
Show Notification.
Device Output.
These actions will be performed once input signal is detected on at least one Device out of the selected.
Why Event may work incorrectly
Too many Devices are monitored and too many Events occur.
Devices that are being monitored are offline.
Action is not configured properly. See the Action's description for details.
Notifications for this type of Event is hidden in system settings. See "Notifications" for more details.
Server Failure
Occurs if Server is down (either hardware/software issue or manual shutdown). In this case, all Devices hosted on
Server are dropped offline.
Basic Parameters
None
Advanced Parameters
Schedule (see "Setting up Schedule for Tracking Events").
Why Event may work incorrectly
Notifications for this type of Event is hidden in system settings. See "Notifications" for more details.