User Manual

DW Spectrum 3.0
Rev. 072017 Page | 97
2. Check the cameras to record, then click OK (Cancel will discard changes).
Advanced Parameters
Fixed Duration – the duration of the bookmark. If checked, Pre-Recording can be set as well. It specifies the amount
of time to bookmark before the event. Can be unchecked for the following continuous events: Motion on Camera,
Input Signal on Device, Generic Event. If unchecked, Bookmark will continue until the event stops. Additionally
Pre-Recording and Post-Recording can be set. They specify the amount of time to bookmark before and after the
event.
Tags that will be added to Bookmark.
May be caused by
All Events.
Why Action may work incorrectly
Recording is not enabled on Camera that is used for bookmarking. Refer to "Modifying Recording Schedule" for
information on how to enable recording
Event is not configured properly. See Event description for details.
Trigger Output on Device
It is possible to generate output via two different methods:
 Output – generates output on Device(s) while Event occurs and stops when Event ends.
 Device output for 30 seconds – generates output on Device(s) when Event occurs and stops output in 30 seconds.
Basic Parameters
Device(s) output is triggered on. To specify: