User Manual

DW Spectrum 3.0
Rev. 072017 Page | 98
1. Click on Select at least one Device in the desired row on the Alarm/Event Rules form (see "Configuring Events
and Actions (Admin Only)"). The following form will appear:
2. Check the Devices to trigger output, then click OK (Cancel will discard changes).
To select all Devices on a specific Server, check the corresponding box. To filter search, use the Filter box. Filter
criteria is the same as search (see "Search"). It is possible to Drag'n'Drop the selected Devices from Resource Tree
onto the Action's advanced settings form.
IMPORTANT. To trigger output signals, output must be supported on Device. If the selected Device does not
support output, then the corresponding message will be displayed (see above).
Advanced Parameters
Output ID – I/O Module port to route signal (see Setting Up I/O Modules).
Auto-reset in (sec) – if checked, the output will be reset automatically after the specified period of time.
May be caused by
Any events – Device output for 30 seconds.
Motion on Camera, Generic Event and Input Signal on Device – synchronous output. Output stops when motion or
input are stopped.
Why Action may work incorrectly
Output is not supported on some Devices.
Output and Device output for 30 seconds are slightly different.