User Manual
Table Of Contents
- Working with DW Spectrum
- Opening and Closing DW Spectrum Client
- Connecting to DW Spectrum via Web-Client
- Launching DW Spectrum in Compatibility Mode
- Connecting to Enterprise Controller and Working Offline
- Introducing User Roles
- DW Spectrum User Interface Overview
- DW Spectrum Quick Start
- Obtaining and Activating DW Spectrum Licenses
- Obtaining and Configuring Media Server’s Additional Settings (Admin Only)
- Cameras and Encoders Management
- Viewing Full Camera List
- Adding Cameras and Encoders
- Setting Up Cameras
- Setting up Analog Cameras
- Renaming Cameras
- Obtaining Camera’s IP, MAC, Firmware and Model
- Configuring Audio on Camera
- Configuring Camera's Authentication
- Setting up PTZ
- Setting Up Fish-Eye Cameras
- Setting up Recording Schedule
- Setting up Motion Mask and Motion Sensitivity
- Configuring Proprietary Camera Parameters
- Adjusting Secondary Stream Quality
- Setting Same Parameters for Multiple Cameras
- Swapping Cameras between Media Servers (Admin Only)
- Diagnosing Offline Cameras
- Deleting Cameras (Admin Only)
- Configuring Events and Actions (Admin Only)
- Tracked Events
- Setting up Schedule for Tracking Events
- Motion on Camera
- Camera Disconnection/Malfunction
- Storage Failure
- Network Issue
- Camera IP Conflict
- Input Signal on Camera
- Media Server Failure
- Media Servers Conflict
- EC Connection Lost
- Licenses are not Configured
- E-mail is not Set for Users
- E-Mail Server is not Configured
- Error while Sending E-Mail
- Storages are not Configured
- Actions that DW Spectrum Can Do
- Default Rules
- Viewing Events Log
- Tracked Events
- User Management
- Layout Management
- Creating New Layout
- Setting up Layouts
- Assigning Layouts to Users (Admin Only)
- Deleting Layouts (Admin Only)
- Opening and Closing Saved Layouts
- Backing up and Restoring DW Spectrum Database
- Playback in DW Spectrum
- Screen Recording (Windows Only)
- Upgrading DW Spectrum
- Troubleshooting and Contacting Support
- Glossary
73
DW Spectrum User Manual
Digital Watchdog
Motion on Camera
Occurs if motion is detected on Camera(s).
Basic Parameters
Camera(s) motion is detected on. To specify:
1. Click on Any Camera at the desired row on the Alarm/Event Rules form. The following form will
appear:
2. Check the cameras to detect motion, then click OK (Cancel will discard changes).
To select all Cameras on a specific Server, set the flag on it. To filter search, use the Filter box. Filter
criterias are the same as search (see "Search"). It is possible to Drag'n'Drop the selected Cameras from
Resource Tree onto the Event's advanced settings form.
IMPORTANT. To detect motion, recording must be enabled on Camera. Refer to "Modifying
Recording Schedule" for information on how to enable recording. If the selected Camera is not being
recorded, then the corresponding message will be displayed (see above).
If cameras are not specified, motion will be detected on all the cameras that support it.