User Manual
Table Of Contents
- Cautions
- Read Before System Operation
- Signs of Caution and Warning
- General Warning
- Cautions about the Power
- 1. Getting Started
- 2. Startup Wizard
- 3. Operation
- 4. Setting
- 5. Web Surveillance through Internet Explorer
- 6. Q & A
- 7. Specifications
User Manual | 28
b. Make sure the ftp information is entered correctly (see section above).
c. Enter your convenient time at CHECK TIME and then click SAVE.
• Video signal: Check the right video signal (NTSC or PAL). This setting should match the
NTSC/PAL selection switch located on the rear panel. Video images might heavily shake
and blink if NTSC/PAL is not properly set.
• IP address: Shows the DVR’s current IP address. It can be set at MENU > NETWORK >
NETWORK.
• Auto IP: Shows the DVR’s IP address.
• MAC address: Shows the unique identity number for the DVR.
• System monitor: Monitor the system performance and condition.
• Keypad beep: User can turn on or off the beeping sound of key pad.