User Manual

6.4 Event Configuration

Event configuration includes four submenus: Object Removal, Exception, Line Crossing and

Intrusion.

Note: Some software versions of this series of cameras may not support the following

functions. Please take actual displayed interface as final.

6.4.1 Object Removal

To set object removal:

Go to ConfigÆEventÆObject Removal interface as shown below.

1. Enable object removal detection and then select the detection type.

x Enable Left Detection: The relevant alarms will be triggered if there are items

left in the pre-defined alarm area.

x Enable Item Missing Detection: The relevant alarms will be triggered if there

are items missing in the pre-defined alarm area.

2. Set the alarm holding time and alarm trigger options. The setting steps are the same

with that of motion detection. Please refer to motion detection chapter for details.

3. Click “Save” button to save the settings.

4. Set the alarm area of the object removal detection. Click “Area” tab to go to the

interface as shown below.