Instruction manual

REMOTE CONTROL*

1) Set the camera ID in OSD menu.(The default setting is “001”)

NOTE : If the camera ID is modified, the new camera ID must

be set, and the power must be turned ON and OFF. Then the

camera is able to recognize the new ID.

2) Press the “KEY” and the camera turns into the standby image.

The LED flickers for 20 seconds.

3) Input ID number of CAMERA to Remote Controller ID number.

After you input the ID number, LED light is turned on, and the

remote controller is ready to set the camera.

NOTE : The ID number must be 3-digit.

REMOTE CONTROL Instructions

4) ZOOM IN (+) / ZOOM IN (-) Key

These are for controlling lens zoom, and selecting the zooming

area of alarm function.

5) Select the desired area where you wish to observe the movement of

objects. And then select the zooming range by pressing “7” wide key.

6) Please save alarm generating zooming range by “8” tele key.

If ALARM generating zoom range is smaller than ALARM

standby range, ALARM Zoom range setting will not be saved.

7) If select “9” ON/OFF key, product operates automatically

from tele to wide 1 time, and then the alarm function starts.

8) Please press “9” key to cancel the alarm function or to

reselect the alarm zooming area.

NOTE :

Press [KEY] + [ID] (Default is “001” for ID=1)

Press [ENT] to access the Menu

Note : The camera ID is a 3-digit number.

Key Button

Menu Access and Control

Zoom Function Control

Motion Alarm ON&OFF

ID Buttons