Instruction manual

23
DAY & NIGHT
D&N MODE
AUTO Camera switches between day and night automatically depending
on light level. Camera will stay in color mode when there is enough
light. Camera will switch to B&W at night or other low light
environments.
If AUTO is selected, please define the following settings:
*BURST: If ON is selected, the camera provides a color burst signal
in night mode. If OFF, no color burst signal is provided.
*COLOR->B&W: Adjusts the light level at which the camera switches from
*day (color) to night (B&W) mode. The higher the number, the lower the light level.
*B&W->COLOR: Adjusts the light level at which the camera switches from
*night (B&W) to day (color) mode. This number should be lower than the value
* *of COLOR->B&W above.
*SMART IR: ON/OFF. If using IR LEDs, ON is recommended.
*READ TIME: Time interval delay before switching from day mode to night
*mode. It is adjustable from 3 seconds to 12 seconds.
*EX_IR INT.: AUTO/EXT. If using IR LEDs built into the camera, select AUTO.
*If using external IR LEDs separately, select EXT.
COLOR
Camera always stays in day/color mode.
B&W Camera always stays in night/B&W mode.
NIGHT C.
0 ~ 100 Color will be reduced in low light conditions.
(This level cannot be adjusted when 3D-DNR is ON.)
NIGHT A.
0 ~ 100 Edge sharpness will be reduced in low light conditions.
(This level cannot be adjusted when 3D-DNR is ON.)
EXIT JUMP
SAVE & EXIT Save the current settings and exit the OSD menu.
EXIT Exit the OSD menu without saving the changes.