Technical data

Utility Software for MS-DOS
98 VIPA GmbH CP486 ⋅ 00/14
C:\SD\SDLOAD
FLASH-PROMs resp. EEPROMs/PEROMs can be programmed:
1 Am28F010-150,P28F010-150
2 Am28F020-150,P28F020-150
3 Am28F040-150,P28F040-150
4 AT28C010-150
5 AT28C040-150
6 AT29C010-150
7 AT29C040-150
8 AT29MC010-150
9 AT29MC040-150
Please indicate the number of the ROM-type you used: 2
Please indicate the number of modules specified above
(2,4,6,8): 8
Please indicate the base address, you specified on the silicon disk board.
Input as Hex value: C00000
The contents of a file generated by SDGEN or the contents of a logical drive can be trasferred in
the silicon disk. Indicate the file name or the drive specification:
C:\EPROM.000
The contents of the file C:\EPROM.000 will now be transferred to the FLASH-PROMs. If the
program terminates without error, the FLASH-PROM disk is to be accessed as drive E:. The
contents of drive D: and drive E: are the same. However drive E: is write-protected. If the silicon
disk is specified as drive A: at address C00000hex in the BIOS-Setup, this program memory can be
used for booting as well.