Technical data

Utility Software for MS-DOS

CP 486 ⋅ 00/14 VIPA GmbH 93

For transferring purposes of this master to the FLASH-PROM disk, the program SDLOAD is called

and the following parameters are entered:

C:\SD\SDLOAD

Following FLASH-PROMs or EEPROMs/PEROMs resp. can be programmed:

1 Am28F010-150,P28F010-150

2 Am28F020-150,P28F020-150

3 Am28F040-150,P28F040-150

4 AT28C010-150

5 AT28C040-150

6 AT29C010-150

7 AT29C040-150

8 AT29MC010-150

9 AT29MC040-150

Please enter the number of the ROM type used by you: 2

Please enter the number of modules specified above

(2,4,6,8): 4

Please enter which base address you have set up on the silicon disk board.

Entry as hexadecimal value: C00000

Either the contents of a file generated with SDGEN or the contents of a

logic drive can be transferred to the silicon disk.

Please enter the file name or the drive label:

The contents of drive D: is transferred now to the FLASH-PROMs. If the program has finished

without errors, the FLASH-PROM disk can be responded as drive E:. The contents of drive D: and

E: is the same. But the drive E: is write-protected. If the silicon disk is set to address

C0 0000hex as drive A: in the BIOS-Setup, then this silicon disk can also be used for booting.