Use & care guide

• Wrong polarity Protection,

• Negative delta voltage protection,

• Zero delta voltage protection,

• Timer Protection,

• Temperature protection via built-in cooling fan,

• Cooling fan failsafe protection.

The REZAP® Pro, RBC889 complies with the following International

Standards for electrical safety:

• AS/NZS 3108:1994; AS/NZS 3350.1:2000; AS/NZS 3350.2.29:2001

• EN 206041A; EN 60335.1; EN 60335.2.29

• EMC & C-Tick (AS/NZS 1044:1995); CE (EN50082-1)

• FCC Part 15 Class B - ANSI C63.4-1992

• CSA Technical Information Letter No. Q-13 (Battery Charger for Charging

Alkaline Batteries)

QUICK START

STEP 1: TURNING THE CHARGER ON

• Plug the 12V switching power supply into a proper indoor electrical outlet

and connect its output cable to the 12V input socket at the back of the

charger. Switch on the power from the mains, the blue LED lights up

indicating the charger is active and ready for use.

STEP 2: CONNECTING THE BATTERIES TO THE CHARGER

• Ensure that batteries are in good condition before charging them. DO

NOT attempt to charge any battery that has sign of rust, chemical leakage

or deposit on the terminals. These should be disposed of immediately to

avoid subsequent damage to charger and/or electronic devices.

o Although battery leakage found on some faulty, damaged or old

batteries will typically not cause immediate damage to unprotected skin,

it is best to avoid contact, or if contact occurs, immediately wash the

exposed area with soap and water.

ENGLISH